Generally 1.6 is working pretty good using a new profile. I have not found any issues yet.
I'm using the CSIO shifter adapter(adds two physical switches) and the range and splitter have to be switched twice each time to work. It should be once to change the range or splitter. Anyone using this shifter adapter?
CSIO Switches not working properly
Re: CSIO Switches not working properly
No problems here. Both range and splitter levers work fine.
Never argue with idiots. They bring you down to their level and beat you with experience.
Re: CSIO Switches not working properly
Did you remember to use the "Shifter Toggle use Switch Mode" setting under Controls > H-shifter setup.
I believe that is required to have the switches work properly on it.
I believe that is required to have the switches work properly on it.
-
- Posts: 3
- Joined: 03 Mar 2017 01:32
Re: CSIO Switches not working properly
Bought a new truck and it's working fine now. ??? I'll go back and take preconfigured job and see if it still works.
Thanks for the feedback...
Thanks for the feedback...
Re: CSIO Switches not working properly
@ Gazer75
From your description it sounds like this is exactly the problem. Without this setting, it only counts as a full button press after switching it on and then off again.
From your description it sounds like this is exactly the problem. Without this setting, it only counts as a full button press after switching it on and then off again.
Who is online
Users browsing this forum: darkmode666, explosion65, flight50, JoeAlex23, lo24681 and 16 guests