[UPD] Coast to Coast Map - v2.15.49.2 (28 Jan)

[littlefoot22]

Are you using the C2C compatible VivaMexico file and not the standalone?

There's a compatible VivaMexico file? I didn't see that on

[willy1962]

Are you using the C2C compatible VivaMexico file and not the standalone?

There's a compatible VivaMexico file? I didn't see that on

Yes , just like me searching over here : [REL] Viva Mexico Map 2.2 (Sonora)
http://sharemods.com/axuckk2exn1k/VivaM ... .scs.htmll

[bobtavenger]

How old is Mantrid? According to a rumor started by my Mother I was born in 1966. I don't remember being born so it is probably just fake news and I'm not sure I actually exist.

[willy1962]

How old is Mantrid? According to a rumor started by my Mother I was born in 1966. I don't remember being born so it is probably just fake news and I'm not sure I actually exist.

but your making could be started in 1965 from liquid to Mantrid . ?

[Laqueesha]

You should add Harlingen, TX; it would add something to fill out southern Texas. It's a city at the southern tip of Texas, connected to Houston by U.S. Route 77 and U.S. Route 59. Corpus Christi, TX is about roughly halfway between the two cities.

[Ways71]

Wouldn't it be more necessary to add Brownsville, TX? Considering it's the sixteenth largest city in the state of Texas with a population of 183,000 and a metropolitan of 416,000.

[Blackspots]

So, how do I get a sign to exist in the 3hw_dir template?

Code: Select all

00:15:22.246 : <ERROR> Sign template item with id 2908094462 does not exist in template '3hw_dir'

Couple of signs I created while working on Wichita Falls, TX
[ external image ]
[ external image ]

Also, I do not know how to create the barriers that keep you from going on roads you aren't supposed to go on. Nor do I know how to set a speed for a particular road.

[davo22]

So, how do I get a sign to exist in the 3hw_dir template?

Code: Select all

00:15:22.246 : <ERROR> Sign template item with id 2908094462 does not exist in template '3hw_dir'

Couple of signs I created while working on Wichita Falls, TX

Also, I do not know how to create the barriers that keep you from going on roads you aren't supposed to go on. Nor do I know how to set a speed for a particular road.

barriers are easy to place, you can find it in the content browser under building, the one your looking for is called DEAD END, make sure you also go into the properties of that road and unclick show in UI MAP, this will stop the road showing in the UI map after you place the Dead end barrier, speed signs are easy, just place the speed sign where you want to control the speed of that section of road then place another after that bit to change the speed again, from what i've seen, you need to also place them after placing a prefab down or else the road after the prefab will be the default speed. maybe someone else can shed more light on it.

[Laqueesha]

Wouldn't it be more necessary to add Brownsville, TX? Considering it's the sixteenth largest city in the state of Texas with a population of 183,000 and a metropolitan of 416,000.

Good point.

[Ways71]

Honestly, If I were building Brownsville, I'd add harlingen as a scenery city in order to represent the northern part of the Brownsville metro.