Hello guys,
since I've updated my game to 1.27 I can't have my 6x4 tagaxle working correctly (I'm using Scania RJL base as you may know my truck). The fact is that when I have a trailer attached, then I want to lift the truck axle, the front end of the trailer collide into my chassis (I tried vanilla trailer and it's doing the same - and it's not an overweighted trailer it has been double checked). So I'd like to know if anybody else experiencing the same problem I got because it's quite annoying (I usually play with the axle lifted).
Thank you very much !
PS : sorry if a topic is already created about this subject !
6x4 chassis problem
Re: 6x4 chassis problem
You tried vanilla trailer, but did you try vanilla truck?
- LeafeonGold
- Posts: 1846
- Joined: 09 Jun 2013 03:11
- Location: Philadelphia, PA
- Contact:
Re: 6x4 chassis problem
This problem was reported before, apparently something physics related changed with taglift chassis, where when lifted they pull the back of the truck down (you can even see the drive wheels of the truck sink into the ground a little bit).
"Don't try extra hard to make your presence known, but make sure your absence is noticed."
Intel I7-4790K |//| XFX Radeon RX 590 8GB |//| 16GB RAM |//| 1TB HDD
Workshop |//| ATS Screens |//| ETS2 Screens
Intel I7-4790K |//| XFX Radeon RX 590 8GB |//| 16GB RAM |//| 1TB HDD
Workshop |//| ATS Screens |//| ETS2 Screens
Re: 6x4 chassis problem
@SiSL : not yet.
@RiXeN : is there any solution to fix that then ?
Thanks for answering !
@RiXeN : is there any solution to fix that then ?
Thanks for answering !
Re: 6x4 chassis problem
Backaxel with singles! Apparently 4 wheels are too heavy
Who is online
Users browsing this forum: No registered users and 6 guests