Any news in this front?
Using G25 and doesnt matter whether i have mods or not, i feel it the same:
When clutch is slipping and i give the truck full throttle:
1.) Truck accelerates way slower than when it gets rolling (clutch released)
2.) at full throttle RPMs do not rise even over 800 (even though at 1200 there is a peak torque).
This means the engine energy is massively being lost somewhere - there is way much less torque at wheels (as expected), yet the engine load is the same as when clutch is not pressed (which is rubbish).
I would assume SCS modeled the manual clutch as a torque converter, which is just sad.
Truck stalling
-
- Posts: 800
- Joined: 30 Jul 2017 18:09
- Contact:
Re: Truck stalling
@deekay773 Sounds more like your gas pedal is busted. Did you go into settings→controls, to see if your pedal is working correctly?
Re: Truck stalling
I recently started playing ETS2 with a G29 (wheel, pedals and gearbox). Running in splitter mode, no automatic engine etc. Was constantly stalling at the slightest incline. After reading through this post, I looked at my slider settings in game, and realized my clutch was going from 0 to 50 as soon as I applied even the faintest of pressure. After playing around for a few seconds, I found that putting 'Clutch axis mode' to Inverted and Centred, and clutch range to max, fixed the issue. Checked a few places where I constantly stall, using the original settings and the new values. Massive improvement.
Who is online
Users browsing this forum: No registered users and 2 guests