Rigid Chassis Addon for Eugene's Scania NG by Kast 13.05.22)

[Jogibaer]

Hello everyone, I have started ETS2 again for a long time and currently have a problem with the repaints for the rigid chassis for the Scania S and R from Eugene. The repaints do not fit when I build them. Where do I make the mistake ? The Skin is from @Wexsper Truckstyling from th Workshop.

Regards Jogibaer.
[ external image ]

[ external image ]

[m1keY]

@Jogibaer skinningtemplates for the boxes are different from the previous versions ... is the skin updated for the new ?

[Jogibaer]

It can be @m1keY , the repaint is from 21.12.2021, that will be it.
Regards Jogi

[erkinalp]

Where do you see P cab?

One of the common uses of P cab in long haul is double decker car transporters with full trailers, where you see one of the cars sitting right above the cab (yes, both the rigid truck and the full trailer is loaded with cars in such transporters).

[xXCARL1992Xx]

what was the logic behind this post 3 years after ?

[erkinalp]

I always had that request in mind, but had forgot to post back then xD

[ggalip16]

This dude is incredible.

[Jogibaer]

Hello @Kast, I think I have found another small fault with your Rigid chassis respectively the Ekeri Box. On the right side in the direction of travel, the lower part of the frame of the Ekeri box is too far up. This makes it difficult to make repaints.

Regards Jörg.

[ external image ]

[ external image ]

[xXCARL1992Xx]

thats not a bug, that is how the box is made

[Jogibaer]

OK, then where do I have the error in thinking about repainting?


[ external image ]

[ external image ]