Plaster & Sons Gate Issue Please & Thank You

[LarryA]

To whom it may concern,

Thank You for Your Kind Reply and Response.
Would someone please and thank you do a test.
Older than rocks and read hot to report bugs. Please if I made a mistake is not intentional.

New Carrer about the 15th load. Lost count. Mods installed. Yes. Active Mods No. Sleep required disabled.

Quick Job.
Shipper Plaster and Sons. Stockton, Ca.. Destination Gallup, Nm.. Time 12:52 A.M...
Cargo Lift Truck. HH Load
Possible bug the exit gate would Not Open. Maybe I missed a step or got lost?????
Checked gamelog.txt warnings and errors. Mainly could not find Texarkana and a few other cities in Nebraska.

Closed ATS. Verified ATS File Structure. Changes after verification Required 0. None.
Shut down computer. Cleared VAS. Power switch Off. Held down power button three minutes. Booted computer. Waited 15 minutes after boot. Allow all Windows 11 back ground apps to load.

Edit: Forgot to mention logged back into Career. Gate would Not Open. In order to exit the Plaster and Sons Yard had to tap F7 request a tow to the nearest repair in Stockton, Ca.........
Took a screen shot not Certain how to post a screen shot...

Windows 11 Professional
CPU: Intel I9 12900Ks
Memory GSkill DDR-5 x 2 Kit. 64 Gbs Total
GPU: Evga 3080 TI
Monitor ViewSonic Elite 32 inch flat screen 144 Hz 3840 x 2160
In Game 72 FPS Locked
Settings Ultra and High.

Thank You Again for your Kind Response.
Have A Great Day

[Madkine]

Please follow the bug reporting process.

Game logs are important.

*Try getting your truck really close to the gate. Once its almost touching it should open.

[LarryA]

Please follow the bug reporting process.

Game logs are important.

I understand the game logs are important. Un fortunately I deleted the gamelog file.

*Try getting your truck really close to the gate. Once its almost touching it should open

Pulled Forward slowly the Front bumper was barely touching the Gate. Made several attempts to get the Gate to Open.
The Amber warning lights never came on. The Gate did Not Open....

Please run a Test and see if the Gate will open.

Thank You For Your Response.

Have A Great Day

[Drive Safely]

@LarryA - The gates are all open at Plaster & Sons when I visited there (Gallup, New Mexico)

[Madkine]

@LarryA Make sure emergency brake detection is set to vehicle only. Otherwise you might not be able to get close enough.

[nautofon]

@Drive Safely The OP indicates that the issue is in Stockton, not in Gallup.

In order to exit the Plaster and Sons Yard had to tap F7 request a tow to the nearest repair in Stockton, Ca.........

The Stockton one is indeed problematic.

[Drive Safely]

@nautofon @LarryA - Thanks. I checked the Stockton Plaster & Sons just now and the gate opened for me as I got close to the gate.

I don't have the emergency braking system enabled for the truck though. If you have it set to full detection, it will stop you just shy of the gate opening trigger... :/

[mopar93]

Possible bug the exit gate would Not Open. Maybe I missed a step or got lost?????

I haven't tried that particular location yet, but I can say that I had an issue with approaching a gate from the outside at another location. I can't remember where it was now. But, I eventually discovered that if I backed up and approached again further to the right that it would open. Maybe you can try moving further to the right. I'm not where my sim rig is located right now or I would try it myself. But, I think you could test without committing to a load. Just enter into the depot and then turn around and approach the gate after it closes to see if you can get out. Of course, I guess if it still doesn't open, you will have to get a tow.

[Davey J]

I have experienced the same issue when leaving the Plaster&Sons depot in Stockton. When I approached the far left side of the gate, where the gate motor and orange light is, the gate eventually opened.